PROGRAMMING THE SYSTEM OPERATION MODES USING DIP SWITCHES
On the back wall of the SCHER-KHAN MAGICAR II block there is a panel of four DIP-
switches, for programming the operating modes of the system depending on
design features your vehicle. Functions Programmable
DIP-switches are set during installation of the system in the installation
center
do not belong to service functions, they can only be changed in
installation center.
ATTENTION!
Incorrect DIP switch setting
can lead to wrong work car engine in
remote time and auto start, as well as to
accident or vehicle damage. Attentively
see the purpose of the DIP switches.
Position
switch
Voltage
yellow/black
C5, at which
stem a
believes that
car engine
bill launched
press “Sensor
nerator".
Engine working time
ventilator for warming up
with automatic
and remote
startup (values
brackets for auto
diesel vehicles
engine).
selected
sensor sensor
launch
engine d.
Box type
your
car
OFF(ORG)
generator)
(25 min. for diesel)
generator
manual box
generator)
(45 min. for diesel)
Sensor
tachometer
Automatic
Transmission
ATTENTION!
If the car is equipped with an automatic transmission
gears without a neutral safety switch,
use the system operating mode for vehicles with
mechanical box gears. Set DIP#4 to
, OFF position. j
setting
sensor
strike
To increase the sensitivity of the shock sensor, turn the knob on the body
sensor clockwise.
scheme
connections
central
castle
system
SCHER-KHAN MAGICAR 11
SCHEME 2
TYPE1 will require two diodes (eg 1H4001).
management
required
impulses
negative polarity. be careful
make sure it's not TYPE 3.
Switch
at the door
^ Orange
Q E >) Rubbing
o i< ------- ^
i j Blue_______ 1^
i >) Locking
management
central lock
factory block
management
central lock
SCHEME 3
required
two diodes (for example 1H4001) For block
control pulses are required positive
polarity.
Switch
at the door
Blocking
Unlock
SCHEME 4
required
external relays.
Blok
management
needed
impulses
change
polarity.
Necessarily
make sure it's not TYPE 1
or TYPE2,
if you find an unidentified wire, then disconnect it
check the operation of the lock with the lock switch. If one direction works, then
this is not TYPE 3, but TYPE 1,
In TYPE 3, if the release wire
locking
disconnected central locking will not
work at all.
SCHEME 5
TYPE 4 will require two external relays.
Electric vacuum lock. On
wire, a signal appears
the doors are unlocked
and "MASS"
when the doors
programmed for
seconds
central lock control impulses.
CONNECTION SCHEMES
At the end of 2013, a new product from the Mega-F company appeared on the market of security systems for cars! This car alarm SCHER-KHAN MAGICAR 11, which belongs to premium devices. This model was developed by Russian specialists. The MAGICAR 11 security complex is fully adapted to our operating conditions and today has no identical analogues. The engineers of the manufacturing company managed to create a system that is practically invulnerable to any hacking methods with subsequent penetration into a guarded vehicle.
Such phenomenal resistance to computer and intellectual hacking methods was achieved through the introduction of the latest MAGIC CODE ™ PRO 3 control signal encoding algorithm, based on double way encryption with two private keys. The first key is intended only for starting the system during the installation of the alarm, and the second for encrypting control commands. Such innovative solution, made it possible to encode any command from the key fob with a unique key that is used only for this particular device. 
Advantages of car alarm SCHER-KHAN MAGICAR 11
ATTENTION! Found a completely simple way to reduce fuel consumption! Don't believe? An auto mechanic with 15 years of experience also did not believe until he tried it. And now he saves 35,000 rubles a year on gasoline!
In addition to excellent resistance to burglary, the SCHER-KHAN 11 security complex has a number of advantages that distinguish it from devices from other manufacturers in better side. Below is full list such advantages of the device.
- An excellent combination of car alarm functions with standard ones electronic devices modern vehicles, thanks to an improved built-in data transmission unit for digital buses car K-Line and CAN. Thus, additional comfort is created for the owner of the car, since the on-board electrical equipment can be controlled directly from the key fob of the security system.
- Alarm SCHER-KHAN MAGICAR 11 has wide set service options such as "intelligent turbo timer", "PIT-STOP" and "hands-free". These additional functions allow you to automate the process of cooling the turbine after the ignition is turned off, keep the engine running when the key is removed from the ignition lock and automatically turn on / off the security system in the mode of removing / approaching the key fob to the car.
- Car alarm SCHER-KHAN 11 provides car owners with convenient functionality for operation motor vehicle. When the SLAVE option is activated, the arming/disarming control is transferred to the car's standard key fob. The "comfort" function allows you to close the windows and the sunroof, as well as fold the mirrors, of course, if your car is equipped with such options, with one press of the arming button.
In addition, security automobile complex SCHER-KHAN MAGICAR 11 has an excellent communication range up to 2 km and an auto-start function.
The car alarm is designed to be installed on most domestic and foreign car models with any kind of engine. The on-board network must provide a voltage of 12 volts. All electronic blocks devices are installed in the car, and the siren in the engine compartment.
Included in the car delivery set security complex SCHER-KHAN MAGICAR 11 includes a processor unit with the necessary accessories, a main key fob with an LCD display, a duplicate spare key fob, a siren and complete instruction manual, which allows you to independently install the alarm on the car and configure it. The cost of a car alarm, depending on the supplier, ranges from 11 thousand to 12 thousand rubles.
MANUAL
If the TURBO mode is on, turning off the ignition
is delayed until the time specified by the value
programmable function 2-18 (see page 80).
After the launch reservation is completed, the system can
arm and disarm, while automatic engine start
can be carried out both in the armed mode and in the “disarmed” state.
protection” (by timer or remote when held for 2
seconds of the button "II" of the key fob). Shock sensor alarm
does not cancel the ready to run state. Completed status
reservation is maintained until the door is opened,
hood or trunk.
Programmable function 1-18: "Unlocking the door locks
at the moment of switching off the ignition when redundant
launch"
This function allows you to enable or disable this option. If
start reservation is not made, unlocking the door locks in
the moment of switching off the ignition is controlled by the value of the programmed
functions 1-3.
1)
Factory value. Unlocking the door locks at the moment of switching off
Ignition with Start Backup Enabled
2)
Unlocking the door locks when the ignition is turned off when
run reservation disabled
Programmable Function 1-19: "Two Step Removal
off guard"
This feature allows you to enable or disable the confirmation algorithm
disarming using personal code PIN1.
This programmable function has two meanings:
1)
Factory value. Two step disarming is disabled. For
disarming, just press the button "II" of the key fob
2)
Confirmation of disarming is required. If using the code
PIN1 disabled (programmable function 1-6 in factory setting),
it is necessary to press the button "II" of the key fob again. If used
four- or two-digit PIN1 code (programmable function 1-6
has the value II or III), it is necessary after pressing the button "II" of the key fob
SCHER-KHAN MAGICAR A
Siren indicator
Shock sensor off indicator
Vibrating alert indicator
Power indicator automatic control CZ by
ignition
Timer start indicator
TURBO mode indicator
Passive arming indicator
security mode
Door open indicator
Trunk/hood open indicator
Shock sensor alarm indicator
(optional sensor)
Car owner call indicator
Engine running or power indicator
ignition
Parking light indicator
When buying an alarm, in the comments to the order, you must write on which car you will install, so that we can program the built-in matching module with digital CAN and K-Line information buses according to the model and year of manufacture of your car.SCHER-KHAN MAGICAR11
Automotive security system with two-way communication and automatic engine start
The SCHER-KHAN MAGICAR 11 premium two-way security system with automatic engine start is equipped with a new MAGIC CODE ™ PRO 3 radio signal coding algorithm, which is able to successfully withstand any high-tech equipment for electronic hacking of car alarms. The system allows you to confidently and accurately monitor the status of the protected vehicle and control all alarm functions at a distance of up to 2000 m.
The unique coding of control radio signals for SCHER-KHAN alarms has long established itself as a system for building a secure radio communication channel with a long range and high noise immunity. In system Scher-Khan Magicar 11, a new generation of cryptographic protection of radio signals has already been applied - MAGIC CODE ™ PRO 3. This encoding is based on AES encryption algorithms, which are currently established standards for encoding information in the US government and a number of countries Western Europe. To increase cryptographic strength, a double encryption mode is used using individual keys. Such an encryption algorithm makes no sense to manufacture and use any radio scanners, since each system is "individual".
Car alarm SCHER-KHAN MAGICAR 11 has the ability to connect to digital information buses CAN and K-LINE. Thanks to the built-in CAN module, standard electrical equipment is controlled modern car using a car alarm key fob (for example, closing windows, a sunroof and folding mirrors when arming), as well as additional service options (for example, controlling the system from a standard car key fob).
The SCHER-KHAN MAGICAR 11 system implements remote start engine, both when receiving a signal from the key fob, and on command from external device. Considering climatic features countries, this function will allow you to get into a warm car with defrosted windows and mirrors in winter, which is especially important for the northern regions. The function will also be useful on a hot summer day, if the car has stood in the sun, it is possible to start the engine in order to turn on the air conditioner to cool the passenger compartment.
In addition, the SCHER-KHAN MAGICAR 11 car alarm is capable of automatically starting the engine on a timer, as well as at a set time. Additionally, indicators such as the temperature in the cabin or a decrease in voltage can be taken into account. onboard network car. The autostart function can be implemented on cars with automatic and manual transmission, as well as on cars equipped with the "Virtual Key" system.
SCHER-KHAN MAGICAR 11 is equipped with a stylish shock-resistant key fob with intuitive controls and a large highly informative LCD display that displays all the necessary data about the status of the protected vehicle.
The car security system offers extensive service options: the "Intelligent Turbo Timer" function, which automatically determines the time required for turbine cooling and the " Free hands”, designed for automatic disarming / arming when the owner approaches / moves away from the car, etc.
Keyfob communicator functions
Multifunctional 4-button keyfob-communicator with liquid crystal display
Protection against interception of MAGIC CODE™ PRO 3 coded packets
vibration call
Long distance communication with processing unit(up to 2000 m)
Automatic display backlight
Indication of temperature in the passenger compartment (when polled)
Voltage indication battery car (when asked)
Key fob battery voltage indication (during polling)
Battery Save Mode
Current time display
Alarm function
Parking timer function
Indication of engine operating time in automatic start, Pit-Stop and TURBOTIMER modes
Programming the time of automatic engine start (up to a minute)
Economy Power (one AAA element)
Processing unit functions
Ability to connect to CAN bus And K-line car for reading and transferring data
Opportunity to work in SLAVE mode (control with the car's standard key fob) when connected to the CAN or K-line data bus
Implementation of the function of automatic engine start on cars with automatic transmission or manual transmission
Implementation of automatic start on vehicles equipped with a "virtual key" system
Operation of the starting system with both petrol and diesel engines
Starting the engine on command from the key fob
Automatic engine start every 2, 4 or 8 hours
Automatic engine start at a pre-set time every 24 hours
Automatic engine start taking into account temperature, on-board network voltage or by command of an external device
Automatic control of door locks when the ignition is turned on and off, by a tachometer signal or when accelerating
Personal code for disarming the system when the key fob is lost (PIN 1-code)
Personal code for access to the car interior if the key is lost (PIN 2-code)
Two-step disarming (possibly using a personal code)
"Hands free" function for automatic arming/disarming when the owner moves away/approaches the car
TURBOTIMER mode with variable engine turbine cooling time
Pit stop mode
PANIC or JackStop™ mode
Completion function automatic operation engine in automatic start, Pit-Stop and Turbo modes when the system is disarmed
